cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1458
Views
0
Helpful
2
Replies

Using SSH in CiscoWorks to Manage PIX

steve.carlson
Level 1
Level 1

I am trying to get our CiscoWorks to manage a PIX 520 firewall running ver 6.3.3. It seems to get SNMP information but getting and managing the configs has been a problem. When I look in the PIX log I see this message: INFO %PIX-6-315011: SSH session from 10.80.134.21 on interface inside for user "manage" disconnected by SSH server, reason: "packet CRC check failed" (0x02). The session gets set up but then it gets dropped.

I can't find any information on pix message 315011. I can ssh into the pix using putty just fine. Can Ciscoworks even do this?

Thanks,

Steve

2 Replies 2

ywadhavk
Cisco Employee
Cisco Employee

Hi steve,

Not sure what address is 10.80.134.21. Is it that of the CW server?

If so, can you run the below command from the CW server and see what happens?

plink -ssh userid@x.x.x.x

where userid id the id that you use to login to the PIX ip address of x.x.x.x

thanks

yatin

egerritsen
Level 1
Level 1

Steve,

Maybe you already know, but the pix only understands SSH version 1. Putty can also use SSH version 1. I don´t know if you can use SSH-1 with Cisco works .

Edwin Gerritsen

Dhs Informatisering

egerritsen@dhs.nl

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: