Why can't Cisco catch up and do this? It is such a simple concept. Aruba, Ruckus and even Ubiquiti can all do it. I don't mind running a Radius server but dot1x is not suitable for many environments. We have events where 5000 people turn up on first ...
Hi ALL,I have setup a lab in CML for testing multicast using Auto-RP but I cant see traffic flowing from the source to the receivers . I can see the (S,G) entry in the first hop router and the (*,G) entry in the RP .Appreciate any feedback Thanks,Fra...
I have a C930048P-E and it boots into a switch: prompt. I cannot force it into ROMMON nor can I tftp the following IOS file to the switch. switch: setBOARDID=20564IP_ADDRESS=192.168.0.1MAC_ADDR=84:8A:8D:E0:5C:80MODEL_NUM=C9300-48PMOTHERBOARD_SERIAL_N...
we are facing the same issue in beakerd.log.1. Its consuming large amount of disk space and couldn't access GUI at all. post truncate beakerd.log.1 and restarting beakerd.log, we stop seeing below messages. Do we have any fix for this? VMware FMC, 6....
To work around this, we copied the config from a known good router with a similar config. We pasted that into a CLI template with the corrected, device-specific values (site ID, site IP, addresses, etc.) and were able to apply the CLI template succe...
Hello, This might be a simple question: Whenever I open any config or CLI I the application is trying to convert anything in the command line to speech. I have a mac and my terminal and any other command-line application don't do this; just the pack...
I have an issue with my final exam on Cisco CCNAv7 ITN. When I want to take the exam it says "No data available in table".Any solution for this? Thanks!
Hi When nessus scan, we got vulnerability info as below. Any solution can be used for this issue? A remote device is affected by an information disclosure"The IKE service running on the remote Cisco IOS device is affected byan information disclosure ...
We are running on version 3.2.0.542 Patch 4 and the max password history is still limited to 10. May I know if this has been fixed in higher version? Is this limitation being documented somewhere in Cisco KB?
My order number is Order#...6044. I am unable to download CML personal. I purchased this lab on Saturday. I keep getting 503 errors or blank screens. Any assistance would be appreciated. Thanks
N3K-C3548P-10GX Running 9.3(13). Problem is still there, even if bug related to 9.2.2 Bug didn't provide much information. GLC-TE should not have DOM activated. I've confirm the behaviour on a N9K. This generate log error and monitoring alert. ...
Hi all, the issue is present in 17.9.4a as well. HOST(config)#snmp-server group SNMP-RW v3 priv read MONITORING write MONITORING access ACL_SNMP-ACCESS% The access list could not be allocated or an access list with the same name butincompatible type ...