Hello ppl,any ideas on QR (Quishing) protection with ESA SEGs topic?Looks like that even with Image-Analysis feature, SEGs are not able to scan (suspicious) URLs encoded as QRs in message embedded pictures.There is a feature request [CSCvs55128] sinc...
I have been trying to install packet tracer from Cisco after installing Kali Linux in a new machine, and this is what has been happening with the same consistent error. in earlier versions of Debian Dist, the Cisco packet tracer worked fine. Later on...
Hi ALL,I have setup a lab in CML for testing multicast using Auto-RP but I cant see traffic flowing from the source to the receivers . I can see the (S,G) entry in the first hop router and the (*,G) entry in the RP .Appreciate any feedback Thanks,Fra...
I have a requirement to create an ikeV2 S2S with a client and client requires to use Asymentric PSK. However there is no option to configure Local/Remote PSK on the FTD. When i check the same on the CLI, it shows the config and suggests that both of...
Hello everyone, Has anyone else hit this bug on UCCX 12.5(1) SU3 ? I have an active TAC case open but I only see 5 support cases open against the bug. It doesn't appear to be impacting anything other than causing the Application Syslogs to get rota...
We are affected by this bug although we are running a newer version of ASDM v7.19(1)90 with ASA v9.18(3)56."Where used" works for Services but not for Adresses.
I am looking to change the icon of the Room navigator to something else rather than the generic icon.I would like to change the green icon to my own logo or some sort.
Why can't Cisco catch up and do this? It is such a simple concept. Aruba, Ruckus and even Ubiquiti can all do it. I don't mind running a Radius server but dot1x is not suitable for many environments. We have events where 5000 people turn up on first ...
I have a C930048P-E and it boots into a switch: prompt. I cannot force it into ROMMON nor can I tftp the following IOS file to the switch. switch: setBOARDID=20564IP_ADDRESS=192.168.0.1MAC_ADDR=84:8A:8D:E0:5C:80MODEL_NUM=C9300-48PMOTHERBOARD_SERIAL_N...
we are facing the same issue in beakerd.log.1. Its consuming large amount of disk space and couldn't access GUI at all. post truncate beakerd.log.1 and restarting beakerd.log, we stop seeing below messages. Do we have any fix for this? VMware FMC, 6....
To work around this, we copied the config from a known good router with a similar config. We pasted that into a CLI template with the corrected, device-specific values (site ID, site IP, addresses, etc.) and were able to apply the CLI template succe...