Hi, in our network we're utilizing an ASR9k as BNG, running 7.3.2. Due to network design, the interfaces of the router that connect to the network's core are also utilized in the Generic-interfaces-list. This means that whenever we perform maintenanc...
PID : N540-24Z8Q2C-M IOS-XR : 7.8.2 I want to know about smart licenses. The command is enable, but when I apply the command below, it behaves as if the license is off. RP/0/RP0/CPU0:PE-02#show run | inc licWed Mar 27 10:13:34.359 KSTBuilding confi...
Hi guys, When i configure the option b BGP on my ASR 9006 i need to enable the labeled unicast in BGP to the neighbor to see the mpls interface enable in the router, this ASBR is PE/RR inline too. Then I eliminate the labeled-unicast but the mpls int...
IntroductionFeature componentsMonitor sessionInterface attachmentStart/stop packet capturetcpdump shell toolConfiguration examplesSimple SPAN to File configurationSPAN to File configuration with ACL filteringSPAN to File configuration with ACL filter...
Team,,We need to do below similar configuration of ASR1002 in our new ASR9001 please supportip dhcp pool PDY-3network 30.23.0.0 255.255.0.0default-router 30.23.2.1dns-server 8.8.8.8 4.2.2.2bba-group pppoe PDY-3virtual-template 3sessions per-mac limit...
Introduction In access deployments using RADIUS, during the access-accept we can pass reply items back to the NAS which allows us to configure per user configuration to alter the base template config or to apply extra features. These features normall...
Pim{ rp{ static{ address 10.126.1.1{group - ranges{239.0.0.0/24}}}}{Int Fe -0/0/0.0 mode sparse;Version2;}Try to migrate Juniper configuration to Cisco ASR but configuration not working properly
Hi all,I´m trying to set up in a lab enviroment in eve-ng, xr router and we have installed ios-xr 7.2.2 xrv9k image because we need to test few things including L2VPN and pw-ether termination but I can´t figure out for the life of me how I activate o...
I am trying to connect a CP-8851-K9 to a Mitel IP CXii PBX. I am using the sip88xx.11-0-1SR1-2 firmware, but the phone is not registering with the PBX. All what I see is detecting Network. I can see that the phone is getting a valid IP, able to ping ...
hello.I am using PRTG to monitor router ASR9910.The SNMP interface sensor traffic graph appears zigzagging.The scan interval is also set to 1 minute.I heard that some people solved the problem with ifmib cache, so I applied it, but the graph remains ...
We have a requirement to have a virtual router in a Colocation Data Center in Europe. The model we were given by the provider is Catalyst 8000v Autonomous Mode.We need to connect an IPT to it and receive multiple full BGP table instances (multipath) ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: