Hi! The last weeks it has been a big increase of brute force attempts from all over the world to our Cisco ASAs. We use two factors, so we're not to afraid that they will actually access any of our accounts, but the problem is that they manage to blo...
Hi, I have a Mitel 5312 phone plugged into a switchport configured for ISE but when it boots up it gets stuck on DHCP Discovery. If I put the port to authentication open then it goes through and boots up as normal.The logs all look ok but I can't see...
Hi, can you help me with below. I'm having alerts on my Cisco Wireless Controller : %PLATFORM-1-NOSPACE: bootflash : no space alarm assertdevice#dir bootflash:Directory of bootflash:/381909 -rw- 53477376 Apr 23 2024 09:53:33 +08:00 .USWAP.img273 drwx...
The 0 operator mailbox is not monitored. By default all vm boxes had a 0 option that would put you into that call handler.I have changed the caller input for all vm boxes to ignore when someone presses 0, however calls are still being sent to it.How ...
We are a healthcare facility. For past several months we have had several complaints from users that calls are often full of static. We are running CUCM 12.5(1)SU8 and the phones are primarily 8811 running current firmware. We have replaced phon...
Hi all, I have a bit of an issue where I work in that we have a number of very old series 800 routers with either an advsecurity license or a securityk9 license installed, I don't have the smart accounts for any of these (before my time) and I am now...
Hello, I'm having this situation:In the call center we have PCs with softphones installed (Jabber) that replicate the traffic to a recorder in another site.Randomly, we are seeing high levels of Jitter in the flow that is replicated to the communicat...
Hi All,I am newly building trustsec in my environment,trying to add one of the switch under trustsec. Have configured Trustsec settings and COA on the ISE for the switch and added the appropriate aaa commands , radius servers and cts commands.But sti...
Afternoon everyone, I'm trying to connect to an APIC using PyATS and the rest.connector.Rest method, but no matter what, I get authentication failures. Here is my testbed file:devices: apic: os: apic type: apic custom: abs...
Hello when a BD subnet is advertised over an OSPF L3out, i'm seeing tha subnet as E2 external route with metric 20 on the router connectd to BL (VPC link). Why the subnet is shown as external and not internal OSPF route? Why the metric is 20 ? Regard...
So I've been working on my project and I've implemented vlans nad also router stick.Now I want to block connections between vlans that are not same with extended access list but something does not work..Here are the commands that I've writtenip acces...
Hi ,I am facing one issue. AP9115AXI (access point) acquired IP address from DHCP. Confirmed with ARP table on switch.But the command sh cdp nei detail - doesn't show IP address of AP. AP not yet associated to WLC.Any suggestion?With Regards,Ravindr...
i've seen this item "Site Tags AP to WNCd distribution" in best practice of C9800 Design and Deploymentmy quiestion is how can i configure multiple WNCd and where is the location of settings in webui?
