Service Providers

Explore information and join discussions with peers and Cisco about Next-Generation Internet, MPLS, voice over IP and Visual Networking Index.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Browse the Community

Activity in Service Providers

Smart license

  PID : N540-24Z8Q2C-M IOS-XR : 7.8.2 I want to know about smart licenses. The command is enable, but when I apply the command below, it behaves as if the license is off. RP/0/RP0/CPU0:PE-02#show run | inc licWed Mar 27 10:13:34.359 KSTBuilding confi...

Resolved! Labeled unicast enable in option b?

Hi guys, When i configure the option b BGP on my ASR 9006 i need to enable the labeled unicast in BGP to the neighbor to see the mpls interface enable in the router, this ASBR is PE/RR inline too. Then I eliminate the labeled-unicast but the mpls int...

Ignacho by Level 1
  • 184 Views
  • 5 replies
  • 1 Helpful votes

PPPOE configuration on asr9k

Team,,We need to do below similar configuration of ASR1002 in our new ASR9001 please supportip dhcp pool PDY-3network 30.23.0.0 255.255.0.0default-router 30.23.2.1dns-server 8.8.8.8 4.2.2.2bba-group pppoe PDY-3virtual-template 3sessions per-mac limit...

Resolved! Swap labels vrf ASBR

Hi, in BGP option B the ASBR swap label by route o by vrf if the ASBR have the vrf configure? 

Ignacho by Level 1
  • 355 Views
  • 9 replies
  • 1 Helpful votes

Pim configuration

Pim{ rp{ static{ address 10.126.1.1{group - ranges{239.0.0.0/24}}}}{Int Fe -0/0/0.0 mode sparse;Version2;}Try to migrate Juniper configuration to Cisco ASR but configuration not working properly 

PW-ether on XRv

Hi all,I´m trying to set up in a lab enviroment in eve-ng, xr router and we have installed ios-xr 7.2.2 xrv9k image because we need to test few things including L2VPN and pw-ether termination but I can´t figure out for the life of me how I activate o...

CP-8851-K9

I am trying to connect a CP-8851-K9 to a Mitel IP CXii PBX. I am using the sip88xx.11-0-1SR1-2 firmware, but the phone is not registering with the PBX. All what I see is detecting Network. I can see that the phone is getting a valid IP, able to ping ...

IOS XR SNMP monitor graph unstable

hello.I am using PRTG to monitor router ASR9910.The SNMP interface sensor traffic graph appears zigzagging.The scan interval is also set to 1 minute.I heard that some people solved the problem with ifmib cache, so I applied it, but the graph remains ...

jngjng42_0-1710953598625.png
jngjng42 by Level 1
  • 143 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Cisco Catalyst 8000v as an ISP Edge

We have a requirement to have a virtual router in a Colocation Data Center in Europe. The model we were given by the provider is Catalyst 8000v Autonomous Mode.We need to connect an IPT to it and receive multiple full BGP table instances (multipath) ...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: