Hi, as per the topic title is there a command that will allow me to display the traffic stats of a l2transport interface or is this achievable only through SNMP?Thanks a lot
Hi, We´ve been using XRd as a way to do integration testing with our autoprovisioning platform using gnmi.This works great.However I'm currently trying to do end to end testing of the whole solution with actual traffic forwarding across the finished ...
Hi Community!I've some problems with one ASR1002HXI have several deployments in different cities, but with only one, the sessions in some home banking get closed after some minutes. It's not exact, sometimes after 1 minute, other after 4 minutes (alw...
I know well if we have several paths to the destination, we will BGP Best Path Selection . In which case we were obliged to use BGP Best Path Selection Algorithm?
I need to connect two redundant firewalls working as Active/Standby to a single ASR router. The ASR router is having 2 line cards and each firewall is connected to both line cards as per the diagram.What is the best way to ensure high availability du...
Hi, All.I want to integrate IOS router to oxidized. I tried to login with pub key, but IOS asks password. Status, Current ConfigurationVersion RP/0/RP0/CPU0:RTR# sh ver Cisco IOS XR Software, Version 7.9.2 Copyright (c) 2013-2023 by Cisco Systems, In...
Greetings,I am trying to establish CFM connectivity using emulation (CSR1000v).I am running VPLS (Manual discovery) for end to end connectivity.The topology in use is CE4 - PE2 - PE3 - CE6Connectivity in place , what am not able to get the remote mai...
PID : N540-24Z8Q2C-M IOS-XR : 7.8.2 I want to know about smart licenses. The command is enable, but when I apply the command below, it behaves as if the license is off. RP/0/RP0/CPU0:PE-02#show run | inc licWed Mar 27 10:13:34.359 KSTBuilding confi...
I have setup of 4 routers R1 - R2 - R3 - R4 . They are connected as shown. I have also setup a GRE tunnel between R1 and R4. The tunnel status is up and protocol is up. I have configured tunnel source and reach ability related configurations in R1,R2...
Hi everyone,I tried to upgrade IOS-XR from the 6.6.3 version to version 7.6.2 on NCS-55A1-24H and the upgrade failed. I presume that upgrading to version 7.6.2 requires upgrades to lower versions of 7.x IOS-XR as a first step. If that's correct, I wo...
Hello,I have NCS5501 that I get the PCIE Uncorrectable Fatal Error/Surprise Link Down Error on Tomahawk LC. I am trying to look it up to gain a better understanding of what this is. Anyone ever seen this before? Can you clarify what it is refe...
Hi, I have configured SRTE policy on one NCS6K-1(head-end) to other NCS6K-2's(tail-end) loopback address. I have tried both the static policy and dynamic policy as well. Both are not working fine. Here are the quick SR-Configs and ISIS configs. Pleas...
I have two routers with dual links between them with some layer 2 technologies in between, i am using IBGP ECMP to load-balance traffic between them, and I have ISIS as an underlying IGP for internal reachability. I would like to enable the BFD to de...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: