Hello everyone,I'm trying to figure out a frustrating issue. Attempting an install of APSP6 keeps bombing out and I'm unsure what steps to take next. Software: Version 17.09.04aROM: 17.3(3r)Error in question: Dec 13 21:21:01 Eastern: %INSTALL-3-OPER...
Hey everyone,Questions - on a guest WLAN I have client isolation enabled via the Peer to Peer blocking action to drop. I can see it blocks peer to peer unicast traffic, however multicast traffic between peers still flows. I can limit the mdns messa...
Hi Guys, As we know, there is option in Cisco 5520 WLC to mannualy disable any Mac addresses of user to deny network access to him. Is there any disable mac address option in Cisco 9800 WLC?
I'm trying to find a trustworthy source about the assignment algorithm of wireless traffic when many wireless clients send traffic to WLAN associated with an interface group, let's say with 4 VLANs. the documentation below doesn't say anything about ...
We have a 9800-CL Wireless Controller running 17.12.2. We just got a new CW9164I-ROW AP and its registered by the operational interfaces are down due to a regulatory domain error. Is there a way to change the regulatory domain for the access point?...
Wired guests are not able to get out to internet, they can ping only at when payload is set to 1300 bytes or lower, this seems like an MTU issue, but its only effecting wired guest not wireless guest. Setup is a 9800 foreign on 17.9.5 code and 5520 a...
Hi I got a pair of 5520 in SSO mode version 8.10.190. If you want to run OEAP then you need to enable Enable NAT Address on the management interface. The problem is that the "Enable NAT Address" is greyed out: the question is: is it possible to enab...
I'm trying to get environmental stats back from 9136/9166 on Spaces. I've imported the maps successfully and have enabled the IOT service in spaces. I'm still getting errors for the TDL Telemetry under the troubleshooting section which seems to be pr...
Dear All.,My Cisco WLAN CONTROLLER 2504 suddenly started to De-associate Access Points. Attached herewith is the Error Message gotten from the GUI Let me know if anyone has solution to address this thanks.
I am trying to understand Guest Anchoring with the 9800 Controllers. In the 5500 series WLCs you had to access the WMI from the inside network through the firewall to the Anchor Controller Mgmt Vlan on a DMZ. Then create another sub-interface on the...
Hi, We have recently deployed Prime 3.10.2 and added a 9800-L (SW 17.6.4) along with 10 X 9130 APs.. On adding the APs to the site maps within Prime, there is no RF heat maps being emitted from them. Just wondering if any has come across this issue a...
What is the meaning of this Alert and what can I do to mitigate this. (for Unified Access Points)Message: '802.11a/n' interface of AP 'XXX' associated to controller 'XXXX)' is down. Reason: Radio reset due to (56) Radio channel set
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: