Hi I got a pair of 5520 in SSO mode version 8.10.190. If you want to run OEAP then you need to enable Enable NAT Address on the management interface. The problem is that the "Enable NAT Address" is greyed out: the question is: is it possible to enab...
Hi,with some Catalyst C9164 APs we have the problem that the image is corrupt.https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/220443-how-to-avoid-boot-loop-due-to-corrupted.htmlCan the C9164 APs even u-bo...
i've seen this item "Site Tags AP to WNCd distribution" in best practice of C9800 Design and Deploymentmy quiestion is how can i configure multiple WNCd and where is the location of settings in webui?
Hello, I have a C9105AXW-B access point configured for office extend. When the AP is joined to an AireOS WLC (8.10.185.0) in office extend it doesn't broadcast a local personal SSID. When I join the AP to an IOS WLC (17.9.5) in office extend mode I...
We have configured two Lightweight Access Points using a 3504 WLC on Packet Tracer. Both access points are connected to the WLC, and have been assigned IP addresses through DHCP from the WLC. Both also state they are providing the WLAN we created. Au...
I am trying to understand Guest Anchoring with the 9800 Controllers. In the 5500 series WLCs you had to access the WMI from the inside network through the firewall to the Anchor Controller Mgmt Vlan on a DMZ. Then create another sub-interface on the...
We currently have two 9800 WLCs serving our schools. Their configs are virtually identical. When clients connect to one specific SSID on 9800 A, they'll connect at expected speeds using 11ac or 11n protocols. However, when clients connect to the same...
Hi all,I am new to Cisco WLC.I have Cisco Catalyst 9800-40 Wireless Controller and it is running on software version 17.3.4c.I am told to upgrade to the latest one and I have no idea which is the latest one with no bug in it. I tried to download the ...
I have setup a SSID with use web policy using the inbuilt web auth page on the controller. I have setup flex connect profile and selected the central authentication option only. The problem is when i connect to the SSID the captive portal tries to lo...
I'm looking to add another 9120 to connect to my my 9120 running EWC. It seemed to join the EWC and it shows up as an online AP, but it shows as standby, like it's another standby EWC. It also looks as if it has both the AP and the EWC image.I was lo...
Hi all,This is my first time working with EWC, and I'm a bit confused about the joining process of the access point.First, here are the hardware components I'm working with:Access Point: C9120AXE-EEWC: C9130AXE-EWC-EVersion: 17.9.4aI don't understand...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: