The host for my current server (Windows Hyper-V machine with four or five VMs) that handles my email and web sites is going away. I'm planning on moving that physical server to my house and using DDNS to route that traffic in. Realize this is very lo...
Hello,i have a pc connected to VPC Peer Switch (vPC2) which has the secondary role. vPC2 builts a vPC with vPC1. How can i configure the port to always keep up the connection for this device, even when peer-link goes down (dragging out the cables).In...
Hi All,I have 2 networks connected via OSPF. I need to route the connected networks to a third network via BGP.I noticed that BGP peering is established but no entry is visible on the routing table.Below is an extract of BGP config:router bgp 65200.1...
I understand that when implementing configuration changes from vManage to cEdge/vEdge, the changes are made via NETCONF.However, even if no allow-service netconf is set under Interface tunnel, the configuration can be changed without any problem.Why ...
hi,i'll be changing an ISP/BGP peer. my question is, do i negate first the old bgp router-id or just directly configure/apply the new router-id?do i need to do a "clear ip bgp" to establish the new ISP/BGP peer?router bgp 65123 neighbor 63.21.16.4 sh...
hi guys thanks for your suggestions in advancehere is my lab setup sorry for the primitive drawing(TYPO in CT2 Bib1/0/12 it is actually 123.123.123.242/30)i modified ips to fake ones. 10.0.22.1/24 is one of our vlans that has full internet access.CT1...
Hello, Je désire resetter le mot de passe d'un Switch Cisco Cisco N3K(C-31108TC-V). Je n'Ai pas accès au CLI via ssh ou console port. Merci pour vos retours
At my new job, I was told RADIUS hasn't functioned for over a year. I wiped the RADIUS server settings and started from scratch. I'm happy to say, after going thru every cisco device, ALMOST all devices now login via RADIUS flawlessly. There are t...
Is there a better way to upgrade these yet?Obviously, I want to reboot after-hours. The install command still cannot be scheduled.install add file flash:cat9k_iosxe.17.09.05.SPA.bin activate commit prompt-level noneIf I do not do prompt-level none th...
Hi, I'm trying to configure a connection between 2 house network as in the image and I need help on how to configure the switch to make all device able to connect to device on the other network. I've check both router and see static routing menu on w...