Hello,We got new terminals Honeywell EDA61K, but we have a problem with connection loss.Wireless LAN Controller is Aironet 2800 Series ME. Terminals randomly lose connection. After a while he returns.I switched the WiFi network only to 2.4. This redu...
Hi all,This is my first time working with EWC, and I'm a bit confused about the joining process of the access point.First, here are the hardware components I'm working with:Access Point: C9120AXE-EEWC: C9130AXE-EWC-EVersion: 17.9.4aI don't understand...
Hello!I need help, I have a problem with limiting the speed for connections on a guest network. I've already studied the manual several times, but I can't figure out if there are any such settings on the Cisco 2504 Wireless Controller, Product Versio...
I am following this document to recover and reset the password for "cmxadmin" https://www.cisco.com/c/en/us/td/docs/wireless/mse/11-0-1/cmx-config/b_cg_cmx1101/performing_administrative_tasks.html#id_131101 When I reset my VM Server and edit ("e") in...
We have wireless and wired devices that uses Bonjour (mDNS) service to discover each other. I need to configure both wired and wireless devices in the same VLAN . We have Cisco WLC 5520 and APs that support flexconnect feature. I need to configure AP...
Hello we have a local 9120axi AP with a 9800LC WLC that seems to be losing connection. The AP is in flex connect, all config looks fine: AdvancedCountry CodeUS Multiple CountriesUSStatistics Timer180CAPWAP MTU1485AP Link LatencyEnabledAP PMK Propaga...
A simple question....If I just knew where to find the answer:Doing MAC authentication on an 5520 WLC, I can see the MAC addresses accepted by the WLC if I issue the command:"sho macfilter summary"Can anyone tell me the equivalent command on a 9800 (y...
Hi community!I posted about some 2702i in autonomous mode, degrading throughput after some time - see post: Autonomous Mode Failing on Aironet 2702i-z-k9 - Cisco CommunityLast days I got a WLC 2504 and other 2702i access points (in controlled - LWAP...
Hello friends, I have a virtual WLC 9800 running version 17.6.5. A client is unable to connect from a specific PC, but can connect successfully from other devices. I have verified the credentials, and they are correct. The specific PC can connect nor...
We want to utilise the 4 ports on the Cisco C9800-L-F-K9 to connect APs - and SVI interface on the WLC have been created on trunk TenGigabitEthernet0/1/0 with wlan 5 and 100 and - access port vlan 5 on TwoGigabitEthernet0/0/0 should these two/4 ports...
Hello, I have a WLC9800 with 9115 APs.For clients, I have a Vlan (100) mapped to an ssid. I want to add another vlan (102) mapped to the same ssid.I have added the vlan 102 (configuration, layer2, add vlan), i have created a vlan group and added both...
I have a 9800-CL in an SD-WAN setup. I have multiple sites that have the same Vlans at each site to make it easier to manage and remember.Ex:NorthSite: data-4, voice-5, wifi-6SouthSite: data-4, voice-5, wifi-6etc...My current WLC configuration has on...