Hello all,20+ years ago I used debug all the time, however not so much so in the last decade. Seems like last time I called TAC on the 3850 debug command they gave me some silly answer that debug was a Cisco TAC command. WFIW All the Cisco.com debug...
Hiin the office where I work, we have an old Firepower 2100 firewall with 16 interfaces,8 ethernet and 4 fiber. So far we have only used 2, one inside and one outside.Now I need to add a server on another ethernet port to be able to reach it via ipse...
I configured cisco dna to send emails as soon as aUser Defined Issue Notification is triggered, configured SMTP, performed the sending test and got the email as expected.But all SYSLOG events that were configured with the subscription for email do no...
Is it possible to build an IPSec VPN tunnel between a cEdge device and Zscaler with the source of the tunnel being in the service VPN say VPN 5 rather than VPN 0?
Hello, I can't manage to give the connected PCs an ip through the dhcp server. My packet tracer + network design are attached. Have currently only started on the bottom part so it's only about the bottom PCs.Thanks in advance for the effort
I have a less then a dozen Cisco 3850 switches that I am working on. I need to configure 802.1x authentication. The issue is the switches are reaching out to Cisco ACS and I need to set up radius server to enable 802.1x. The Cisco ACS I found out ...
I have recently taken over a site that utilizes a Cisco Router to act as their public facing device/firewall. I have been tasked with setting up a IKEv2 S2S tunnel with one of our external vendors, and it will need to be setup on this router.I have w...
First I'll state i also have an open case with Vmware. I inherited a vPC pair that had a number of vPC set up, but the multiple links to the VxRail host nodes were trunk links. We lost the secondary so only the trunks to the primary vPC were up. A...
In Prime Infrastructure, we were using the "Monitor / Monitoring Tools / Clients and Users" Track Clients feature for missing or lost devices.1. Is there a way to export that list of MAC addresses to use in DNAC?2. How do we add MAC addresses that ...
I hope I'm in the right spot......We have a number of Cisco switches and routers from older 2950 switches and 4400 routers to our newest 9300 switch. We have the console port connected to console management switches via RJ45 to serial cables. The con...
Hi All,Looking for snmp configuration for cisco N540x router.I got information in cisco docs.But configuration bit confuse.Can someone please send me actual command to configure snmp in cisco N540x routerThanks,Prashanth
Hi! Can you help me with troubleshoot, I don't know where I am wrong?I don't see on BUH2, route from BUH1 (81.1.210.0/24).I attached config from BUH1, BUH02, ClinicaA01, ClinicaB02, P0.
Hello,are there any best practices on the authentication timer settings?Is it common to let the settings for authentication timer reauthenticate and authentication timer restart on defaults?RegardsSebastian
I was just thinking about how in the early 2000's when I was just a wee little lad (like 18), I wonder a pallet full of Cisco AGS, MGS, IGS, and CGS routers for $1. It cost over $100 to ship it, but it was awesome. I tried using them to study, but ev...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: