Hi all I'm setting up a CISCO LAB to keep me busy in my retirement. My Current network consists of a TP-Link Deco mesh network which works well for my IOT, PCs and internet access. I just got hold of a Cisco 1941 router with a EHWIC D8SGP module. ...
Hi I'm trying to extended a L2 segment using MPLS L2vpn over GRE. I am able to establish the tunnel and get ospf and mpls adjacency also the xconnect between the peer is up but my 2 test pc cant reach each other. This is my PE3 config.interface Gigab...
Hello.I'm working on a simple project and I have encountered an error where I cant access the HTTPS server via any terminal on the network. Any other post I have seen on the subject were either not relevant or I lacked sufficient knowledge to underst...
Hello,I have a switch I am unable get a prompt on the console port.I can SSH to it, and have confirmed that the baud rate and stop bits are correct from the console switch. There are two other switches that I can console to.The differences are that t...
I'm a newbie but have a question: I upgraded my Palo (firewall ) and the port that the firewall is plugged into err-disables out. After doing a SHUT, NO SHUT the port came back to life. Any thoughts on why this happens? It seems to happen anytime I u...
NOTE: I have done the same test setup with 4000 series routers, and routing works fine.I have successfully setup 3 SVI (Static Virtual Interface) tunnels with IPSEC between 2 9300X switches.- I can ping the tunnel IPs- I can ping each VLAN interface ...
Hallo All! What is the reason that when enabling Telemetry on C9300 Series Switches, only Application Name, Usage and Througput are shown? Switches configured with telemetry show only Application Visibility (Name and Throughput) in DNA center. Why is...
I configured a Cisco Catalyst 2960 Switch. I set vlan1 as the ip address of the switch as well as interface 1 with 192.168.1.1 with a class C subnet. Strangely I am not able to access the GUI, ping the switch or Telnet directly. However, I am able to...
Hello everyone,I am a teaching assistant at an university. I'm using Packet Tracer to configure VLANs based on MAC addresses, but when I try to use the 'vlan database' command, I encounter the following error:Switch#vlan database^ % Invalid input det...
I am installing DNA Center 2.3.7.3 on an exsi host. The install fails with the following message.Traceback (most recent call last):File "/usr/local/lib/python3.6/dist-packages/maglev_config_wizard/commands/silent.py", line 173, in cliexit_with_error...
I have a new project that we are considering to use IE3400 Heavy Duty series switches to support the remote field sites. I have few design questions:Our network architecture includes a main hub site with core switches (standard Cat-9500 stack) and 22...
Hi, members! 1. I met the following sentence. Is it true or false ? " Only one IPv6 link local unicast address is possible per interface " 2. Can some Cisco devices have the secondary IPv6 link local address on an interface ? I already read the...
Dear all,I've set manually a specific port, in which have a non-Cisco WiFi 6 Access Point running, to provide 30W to make the PoE+ runs, but the AP itself didn't recgonize the power provided as PoE+.I've adjusted at web interface as well at CLI. Is t...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: