Problem Description:I am encountering an issue with the "set ip default next-hop" command on my n3k-c3064pq-10ge device.Device Information:Model: n3k-c3064pq-10geSoftware:BIOS: version 5.0.0NXOS: version 9.3(13)Configuration Attempt:I am attempting t...
Hi, I am trying to configure SNMPv3 on ios-xr 7.9.21, and I am a bit confused about the role of the community string in SNMPv3, I thought that v3 had an user based model and that community_strings were a SNMP v1/2 concept but when I try to enter the ...
I have been taking a Packet Tracer course, and now I come across this guided activity: Packet Tracer - Troubleshoot a Wireless ConnectionIt tells me the following information:"Before you can troubleshoot the problem, you need to understand which devi...
Hi I have cisco slm248G with flashing system led, I have I serial cable arriving tomorrow so I can attempt to re install the ios. My question is, is ther a persific port I should connect to on the switch with the consol cable or any port from 1 to 4...
Hi,I am getting the following error when trying to ping from PC to server can you please help me regarding this"ping request could not find server please check the name" in cisco packet tracker.I am here with providing my file.Thanks in advance.Kavya...
Hello everyone!I'm not a network engineer but as a subsystem (kernel + filesystem) engineer I know the network concept.Few months ago, I designed a DMZ and configured my 2 node VPC with 6 rack switch.Everything was smoothly working but I started to s...
Hi Community,I want to configure PBR for LAN subnet as when any of the user initiate the traffic for server packet should go to the ISP-2e.g 192.168.40.20 destined to 192.168.16.55 it should follow the ISP-2 reaming traffic should follow ISP-1I have ...
Hi All,What would happen if you configure an SVI eg VLAN 10 with an ip helper and then configure a VLAN 11 without ip helper, but with a physical dhcp server attached in that vlan. You then configure ip directed broadcast on both SVI's.interface Vlan...
Hello, I have a bunch of devices that I have to check on for a "Type 7 password" configured on them. How would I check the config for a "Type 7 password? What commands would I used to find that out? Thanks,
Hola buen dia, Soy Andres Camilo GutierrezTengo una duda con respecto a la configuración de ATM multipunto, tengo R2, R1 y R3, R2 y R3 los configure como atm point-to-point y R1 lo configure como ATM multipoint, este ultimo recibe los dos PVC que est...
Hello, this is most likely a firewall problem but I wanted to ask here before I go that route.I have 2 locations that are connected with the same fiber run. The primary site has an MX250, and 3 stacks of 2960x switches each with 3-4 switches in the s...
Hi,Is it possible to ingest data from external sources into ThousandEyes Synthetic Monitoring module for dashboarding purpose?External source data may be from Splunk, API/JSON results from a script, Text file with metrics data etc.
Hello,I'm trying to figure out why Avaya Phones and PC's are showing up as both statically and dynamically learned. We do not have any mac addresses statically configured. Here is the output of a few ports.Cisco9300# show mac address-table int Gi8/0/...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: