This is a fixed port router with a mix of SFP+, SFP28, QSFP28 and QSFP-DD ports The install guide says they are split between slice 0 and slice 1 with 24 ports per slice How does this translate into the rack/slot/instance/port schema ? is the slice ...
Team,,We need to do below similar configuration of ASR1002 in our new ASR9001 please supportip dhcp pool PDY-3network 30.23.0.0 255.255.0.0default-router 30.23.2.1dns-server 8.8.8.8 4.2.2.2bba-group pppoe PDY-3virtual-template 3sessions per-mac limit...
PID : N540-24Z8Q2C-M IOS-XR : 7.8.2 I want to know about smart licenses. The command is enable, but when I apply the command below, it behaves as if the license is off. RP/0/RP0/CPU0:PE-02#show run | inc licWed Mar 27 10:13:34.359 KSTBuilding confi...
Hi, in our network we're utilizing an ASR9k as BNG, running 7.3.2. Due to network design, the interfaces of the router that connect to the network's core are also utilized in the Generic-interfaces-list. This means that whenever we perform maintenanc...
Hi guys, When i configure the option b BGP on my ASR 9006 i need to enable the labeled unicast in BGP to the neighbor to see the mpls interface enable in the router, this ASBR is PE/RR inline too. Then I eliminate the labeled-unicast but the mpls int...
IntroductionFeature componentsMonitor sessionInterface attachmentStart/stop packet capturetcpdump shell toolConfiguration examplesSimple SPAN to File configurationSPAN to File configuration with ACL filteringSPAN to File configuration with ACL filter...
Introduction In access deployments using RADIUS, during the access-accept we can pass reply items back to the NAS which allows us to configure per user configuration to alter the base template config or to apply extra features. These features normall...
Pim{ rp{ static{ address 10.126.1.1{group - ranges{239.0.0.0/24}}}}{Int Fe -0/0/0.0 mode sparse;Version2;}Try to migrate Juniper configuration to Cisco ASR but configuration not working properly
Hi all,I´m trying to set up in a lab enviroment in eve-ng, xr router and we have installed ios-xr 7.2.2 xrv9k image because we need to test few things including L2VPN and pw-ether termination but I can´t figure out for the life of me how I activate o...
I am trying to connect a CP-8851-K9 to a Mitel IP CXii PBX. I am using the sip88xx.11-0-1SR1-2 firmware, but the phone is not registering with the PBX. All what I see is detecting Network. I can see that the phone is getting a valid IP, able to ping ...
hello.I am using PRTG to monitor router ASR9910.The SNMP interface sensor traffic graph appears zigzagging.The scan interval is also set to 1 minute.I heard that some people solved the problem with ifmib cache, so I applied it, but the graph remains ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: