We received vulnerability mail from my security team. Could you anyone have solution for this vulnerability CVE-2023-51384 , CVE-2023-48795 , CVE-2023-51385
When a client connect to the HQ via AnyConnect vpn, they can access the HQ local subnet, but can´t access the subnet at the remote office, that has an site-to-site connection to the HQ.Can this be configuret via the Cisco Firepower gui?Cisco Firepowe...
We have FMC and FTD , In FMC we configured Blocked traffic ACCESS POLICY , but while checking in FTD(CLI) one more ACL( Ifc Outside any any allow) showing with same rule-id 26844160. any ideas how to find this ACL in FMCACL in FTD ========access-li...
Team,We have a new Cisco Firepower 1120 just configured with basic configuration.After the admin user I added another user with the "configure user add" command.This new user can SSH to the device but cannot SSL.Further, I want to ensure that this ne...
I have a DMVPN network with 4331 hub routers. Our HQ in Memphis has a hub on AT&T, and another on Lumen. Our New York hub is also a Lumen connection. All are 500Mb up/down. We have about 35 spokes around the US that peer to all 3 routers. BGP is the ...
Good afternoon, Cisco community. I faced a problem when configuring RADIUS server using switch as authenticator. When using router everything was not complicated and worked, example below.But my supervisor said that it is wrong to do it this way and ...
Hi EveryoneOur client for ISE software still uses version 2.6 with pach 10,We will upgrade the software to 3.1 with patch 8, please provide a recommendation link from CiscoI'm afraid that if I downloaded it wrong it would have fatal consequencesThank...
Hello,Our Cisco ISE HA does suffer from some performance issue and by checking the logs, it became obvious that were are dealing with a space issue: Sending SNMPv2 trap for partition /opt/podman/containers/storage/overlay/...merged which reaches the ...
Hello, I recently installed Secure Client 5.1.2.42 on Win11 23H2 (HU language). Setup was OK, I received no error.After starting the client, the application didn't start, the appl. log shows me the this:The name of the modul, which occured the proble...
I have created an external admin group in ISE, which is pointing to an AD group. There are several users in this AD group.Will all the users in this AD group gets ISE admin access or can it be restricted to few users.
Hi, I have one issue with IPSec tunnel Lan-to-Lan between ASA 5525x (v9.8) and ASA FPR 2110 (v9.16). My Tunnel is up but ping between each client was not successful. Both peer status sh cry isakmp sa in "MM_ACTIVE".I ran packet-tracer icmp between pe...
Hi, I'm deploying config from CSM but received error : An error response from the device prevented successful completion of this operation. The device provided the following description: enable password ****** pbkdf2 PBKDF2 hashed enable password ***...
We receive this vulnerability on Cisco C9120AXI-E Access Point, Let me know if anyone has solution for this vulnerabilityCVE ID: CVE-2023-48795https://bst.cisco.com/bugsearch/bug/CSCwi61646?rfs=qvloginhttps://www.tenable.com/plugins/nessus/187315
Hi bros, Our customer is asking us on the ISE bwd requirements for with some specific cases below: The number of EUs are 5000 from many branches, connect to DC/DR through WAN link.How much minimum bwd needed for one user authenticate successfully a...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: