Hello all,When looking at show auth sessions int gx/x detail , I see a field called acct update timeout , and ours is set to 300 seconds with a countdown timer.My questions are:What does this field mean?What resets the countdown timer?How can you cha...
Dears, i am not able to see all the acls with object groups on gui , however in cli i am able to see all acls applied. i have an issue with checking and modifying the acls on gui ( note that i upgraded the switch to the v17.9.4a ). Need assistance pl...
Hi,I wonder if there is a way to send every incoming and outgoing message both to the original destination and to another destination for analyses. Preferably before any scanning or policies interfere.I've tried google, but have not come up with anyt...
We are migrating from our Older Cisco ASA Firewalls to Cisco FTD 2140's. We currently are using WCCP on the ASA's for Transparent Proxy with our WSA Virtual Appliance under VMWare. I was just going to migrate WCCP Configurations to the FTD 2140's w...
Hello,I don't understand how can I use transparent mode using L4 switch (it's load-balancer, right?). I'm friendly with L4 switches, even though I can not imagine the topology and data flow. I have two WSA boxes and I need configure active-backup mod...
I am creating Deployment Profiles from Secure X in order to push Secure Client (and our modules) to workstations and servers. The deployment profile for workstations works as expected, whether using a Full Installer or Network installer. I am now t...
Good day everyone.We are conducting a proof of concept with Azure MFA providing second factor authentication for RAVPN.Our parent agency owns the Azure AD that includes a user account for all our users in our agency.However, we own and manage an in-h...
On my Windows 10 computer, I can connect to the VPN using AnyConnect 3.1.02026 without difficulty. However, once I disconnect, I need to reboot my computer to connect again. When I try to connect the second (and subsequent) times I get the message, "...
Hello,I have a question about migrating a IPSec tunnel from between a Cisco C981F-k9 and a Cisco ASA firewall to a tunnel from the same Cisco C981F-k9 router to a Fortigate firewall. What is the 'best' way to migrate this tunnel?Currently I have conf...
The Cisco Document Team has posted an article. This document describes how to allow specific YouTube channels/videos and block the rest of YouTube in Web Security Appliance (WSA). Know of something that needs documenting? Share...
Hi. After AnyConnect upgrade from 4.10MR2 to 4.10MR7 (pre-deploy) it downloads ISE compliance module 4.3.2403.6145 from ISE upon every connect and tries to install it, although 4.3.2403.6145 module already installed.I know there is a workaround to co...
Hello, I have two ISE 3595 (3.2 Patch 3) physical appliances, one in each Data Centre. They will be end-of-life in a few months. They are currently used for Wired NAC with Posturing, Wireless NAC (corporate, BYOD and Guest and Hotspot). It is also us...
Hello,We had a perfectly functional ISE 2.7 posture deployment, but we had to upgrade to ISE 3.2.We set up another deployment & imported our 2.7 conf into the 3.2. Since then, our computers never go through the full posture process.We're using Anycon...
Hi Community, We have a newly established IKEV 1 tunnel from Cisco ASA to AWS. This tunnel is currently at up state but the traffic is not passing through the tunnel. When we enter the show command "show crypto ipsec sa peer X.X.X.X" output have enca...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: