The Cisco Document Team has posted an article. This document describes the most common issues when you enter a host in Maintenance Mode in HyperFlex. Know of something that needs documenting? Share a new document request to doc...
Hello Bros'I have a question regarding Cisco UCS system with specs as mentioned below:UCS manager 3.1(3b)Chassis 5108Ucs FI 6248upIO module 2208xpDue to creticality I wanted to consult you regarding changing the IP addressing used in the management a...
Hi,So i fired up ACI Simulator using ProxMox Hypervisor.I have set my static IP as follow:IPv4 address: 192.168.1.200/24Gateway: 192.168.1.1the IP address is free and available in my network.The subnet is correct.The gateway is correct.However, i can...
Hey folks,I'm looking to set up an L3out with static routes for an Active/Standby Firewalls pair, as shown in the diagram below. However, I'm feeling a bit confused, especially when it comes to configuring the L3out with SVI. Any advice on how to pro...
When configuring DNS policy for ACI, you can choose whether to use the default profile or create a custom one. Creating and using a custom DNS Profile will not apply DNS Profile configuration to the APICs. If you want your APICs to have DNS configura...
Hello, on fresh installation of ND 3.0.1i on vCenter, Nexus Dashboard Insights service fails while trying to get enabled with message: job/pre-enable has failed: Does anyone have a clue of the reason? I'm running 3-App nodes, it's a small lab set...
The Cisco Document Team has posted an article. This document describes basic steps to troubleshoot FabricPath. Know of something that needs documenting? Share a new document request to doc-ic-feedback@cisco.com Your input h...
Hi, we have replaced a Core switch (6500-VSS) that was connected to the ACI Border leafs. The new core SW is 9500 virtual-stack wise that connects to the same border leafs but on different ports/vpc. We have several EPG extensions that use static por...
This document details a high level checklist for setting up VMM integration, then is followed by some common mistakes/errors and faults to look for. Finally we will cover additional troubleshooting commands to RCA common VMM domain related issues. ...
Hi there everyone, I'm reaching to see if anyone knows how to add new MDS switches into an exisiting VSAN in Nexus Dashboard Fabric Controller (NDFC version 12.2.1.316). This option was available in Data Centre Network Manager (DCNM) by going to Da...
Consider that L3Out Link is not yet in Place between PRD Tnt to ISN RTR ( at left side of the Diagram ). I am evaluating the situation if I bring the L3Out Link between DR PRD Tenant to ISN RTR. At DR Site PRD Tnt through L3Out it will receive Route ...
Default vsan (vsan0001) in UCSM is showing as Admin status okay but Operational status down (major alarm from Monintoring system)=========================================================================================================================...
For anyone having issues configuring UEFI boot parameters when configuring boot-from-SAN, I believe I have figured out a CLI solution, which is much better than the workaround mentioned in the bug report:CSCvt79874 - Cannot set UEFI parameters for SA...