hi all,we have a topology without any redundant link. Every access switch is directly connected with the core switch, and it's a port-channel between access switch and the core. RSTP runs on switches by default, and we do not explicitly configure the...
Am trying to create a new local account on a Nexus 3048 so I can SSH to it if my Radius server doesn't work. Normally, I log in with my AD account which the switch uses Radius for authentication with that. However, when I run the command to create ...
Hello all, The Phone calls work perfectly before applying the QoS but get choppy after applying. I am currently applying QoS on Cisco 9300 access switches but the phone calls are cutting in and out (Choppy). I am using Cisco phones. Below are the con...
HelloSo I wanna verify if maybe this is normal function or a misconfiguration on ACL or a missing one but a DMZ host is mounting a [Samba Share] from an INSIDE Host, on completely different Network, but NO ACL Permitting it... Any ideas?ISR C1111 ...
I am trying to configure a trunk port on a Cisco 3750 that has fiber running to a ruckus 7150 switch.My current config connects the switches but it is only passing vlan1 traffic and I want multiple vlans. Therefore, I configured the port as a trunk o...
Greeting everyone! There is a little problem with configuring tacacs server on ws-2950-24 model switch. The rest switches we have are 2960 series, also 3xxx series and others, more modern versions. We always configured tacacs server this way:tacacs-s...
Mods blocked last post, so trying again. No info here is confidential.Hoping someone can shed some light. I have a switch in a remote location that I can connect to via SSH, but once connected I am unable to run *any* commands. I cannot do "show run....
Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Friday, March 15, 2024 through Friday, March 29, 2024. Our colleagues Pandian Ponnuswamy, Gautami Sinai Neureker and Sankkar R will be w...
Assume that there are three router type devices outside firewall, and one core switch router behind one layer firewalland I would like to hide the router hop of core switch router from traceroute how to modify TTL to less values at router at the most...
I am trying to retrieve all IGMP snooping parameters and the associated multicast forwarding table from a 3850. From the q-bridge-mib, the multicast forwarding table is: dot1qTpGroupTable. But that mib does not appear to be supported. I even tried th...
Dear community I am getting into NetFlow a little bit deeper but cannot get my head around sampling. All i understand so far: We can configure deterministic sampling, that uses a hardware sampler per interface, limiting the maximum number of monitori...
Hi All , I am in the testing phase of migrating to a 9300. So far I have done the below.3850 running 16.3.6 and 9300 updated 17.09.04aI have copied the start-up config to the 9300 - all looks ok apart from the usual ip routes , some interfaces not ...
Hello,are there any best practices on the authentication timer settings?Is it common to let the settings for authentication timer reauthenticate and authentication timer restart on defaults?RegardsSebastian
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: