Cisco Catalyst Center
This community is for technical, feature, configuration and deployment questions. For production dep...
2154 PostsActivity in Networking
PACKET TRACER KEEPS CLOSING AFTER A FEW SECONDS.
I installed, uninstalled and reinstalled the latest version of the Cisco Packet Tracer but everytime I try to do a lab it closes a few seconds after opening it. Can someone kindly help me?
BOOT FAIL C cisco catalyst 9300
When I start the switch, the text BOOT FAIL C appears in the console and the gear indicator, the system, flashes orange, tell me what to do?
Removing Device Pack file from Prime Infrastructure
Hello.On the Software Update page of Prime there is one Pack which i can not install or delete because it is already included in another installation i did before. Now this pack stays on the page and i am not able to remove it. Does anybody know wher...
Is there a way to log the MAC connected to a port on a Catalyst?
hi! I am curious as to whether the requirements requested by the customer will be supported by the Catalyst Switch. The requirement is that when the H.H.H PC is connected to the Catalyst Switch port A, a history of the H.H.H MAC connection to the A p...
CDP Mismatch from CDP: Why?
Switch A, Cisco 9300, VTP mode transparentinterface GigabitEthernet1/0/5switchport access vlan 3switchport mode accessSwitch B, Cisco 3560, VTP mode transparentinterface GigabitEthernet1/0/1switchport access vlan 3switchport mode accessVlan 3 (L2) vl...
IOS not found after factory reset, goes to rommon
Hello,I did a factory reset in my cisco switch 9200L 48 PoE, but after doing that, it seems the switch require to install new OS and there is no copy OS in flash memory. When I try to connect external USB it doesn't respond. What should I do?Here is ...
DNA Center Full Backup Size
Hi, I have a DNAC Server gen 2, configuration with 2 SDA Fabric Site. I managed about 215 Devices (included Fusion Router, Border Switch, Intermediary Switch, Edge Switch, WLC and AP). I doing a full backup but size is so big (~ 213 GB), backup progr...
Cisco Archive config - any changes / Cisco commands
Hello Professionals,I have configured Archive to log config whenever type write memory.I would like to use this auto backup in other way too.Could anyone tell me how to configure followings?1. Is there possible to backup config whenever I make any ch...
internet speed slow from router to core switch
Hi we have cisco 2921 router connected to core sw and internet from the ISP, the issue is that the internet from the core sw is about 150kb while from the router is 10mb.after a lot of testing, I disconnected the router and connected another similar ...
1921 Router Config Help
Hello, I know very little about configuring cisco hardware and need some help..... we are currently running an 1800 router and I obtained a new to me 1921 router and would like to replace the 1800 router with the newer one, I managed to get it factor...
Forward traffic from subnet to another on C3750
hi guys thanks for your suggestions in advancei just reconsidered my whole message. after trying some things. i think i need to set up acl but i'm far from good at it.what would be the ip access-list extended or access-list lines that'd allow me to h...
ISR 4k Netflow not sending data
I've got 15+ Cisco ISR 4000's (a mix of 4331s and 4551s) in our network and when trying to setup Netflow to PRTG, It seems that when I hit 5 interfaces that need to be monitored, there is always 1 that won't come up in PRTG and that doesn't send data...
Multiple sub interfaces with Native vlan's?
Sorry, I am reposting because I want the community to see this because where I previously posted, the thread shows resolved already.I have an ASR 10g interface that is connected to a native vlan1 in a HP switching fabric (8 switches) for databases (i...
vSmart Login Banner not coming before login promt on version 20.9.4
Hello Guys,Good Day !!This is very strange that : on version 20.9.4 the login banner is coming after the login prompt but it is perfectly coming on version 19.2.31 i.e. before login prompt.Would you please help me to fix : i am on version 20.9.4Early...
Minor edit in one of the OpenTelemetry Blog
Hey!I'm Chitransh, part of the team at SigNoz.Thanks for using SigNoz as one of the Observability backend for OpenTelemetry in this blog - https://www.thousandeyes.com/blog/data-observability-backend-opentelemetryI just wanted to point out a small c...
| User | Helpful Count |
|---|---|
| 70 | |
| 39 | |
| 39 | |
| 35 | |
| 34 |
| User | Count |
|---|---|
| 24 | |
| 17 | |
| 16 | |
| 11 | |
| 10 |
