DNA/Catalyst Center is a great tool for surveillance and managing the network. But why cant we connect Catalyst 1000 switches to the Catalyst Center ????????
Hi, I have a DNAC Server gen 2, configuration with 2 SDA Fabric Site. I managed about 215 Devices (included Fusion Router, Border Switch, Intermediary Switch, Edge Switch, WLC and AP). I doing a full backup but size is so big (~ 213 GB), backup progr...
Hello everyone!We have ASR1001x with fullview and ipsec tunnels. We use local policy to forward packets from PA addresses to their respective gateways. When the traffic load is high PBR stop working and the router starts using cef, when there is litt...
I installed, uninstalled and reinstalled the latest version of the Cisco Packet Tracer but everytime I try to do a lab it closes a few seconds after opening it. Can someone kindly help me?
Hello.On the Software Update page of Prime there is one Pack which i can not install or delete because it is already included in another installation i did before. Now this pack stays on the page and i am not able to remove it. Does anybody know wher...
hi! I am curious as to whether the requirements requested by the customer will be supported by the Catalyst Switch. The requirement is that when the H.H.H PC is connected to the Catalyst Switch port A, a history of the H.H.H MAC connection to the A p...
Hello,I did a factory reset in my cisco switch 9200L 48 PoE, but after doing that, it seems the switch require to install new OS and there is no copy OS in flash memory. When I try to connect external USB it doesn't respond. What should I do?Here is ...
Hello Professionals,I have configured Archive to log config whenever type write memory.I would like to use this auto backup in other way too.Could anyone tell me how to configure followings?1. Is there possible to backup config whenever I make any ch...
Hi we have cisco 2921 router connected to core sw and internet from the ISP, the issue is that the internet from the core sw is about 150kb while from the router is 10mb.after a lot of testing, I disconnected the router and connected another similar ...
Hello, I know very little about configuring cisco hardware and need some help..... we are currently running an 1800 router and I obtained a new to me 1921 router and would like to replace the 1800 router with the newer one, I managed to get it factor...
hi guys thanks for your suggestions in advancei just reconsidered my whole message. after trying some things. i think i need to set up acl but i'm far from good at it.what would be the ip access-list extended or access-list lines that'd allow me to h...
I've got 15+ Cisco ISR 4000's (a mix of 4331s and 4551s) in our network and when trying to setup Netflow to PRTG, It seems that when I hit 5 interfaces that need to be monitored, there is always 1 that won't come up in PRTG and that doesn't send data...
Sorry, I am reposting because I want the community to see this because where I previously posted, the thread shows resolved already.I have an ASR 10g interface that is connected to a native vlan1 in a HP switching fabric (8 switches) for databases (i...