HiI'm trying a very simple LAN Automation test where I have one Border manually configured and discovered which I am then going to use as a seed device for my second Border. When I start the LAN automation process the second Border upgraded to my Go...
Hi,after a upgrade from xe 3.11.07 to 3.11.09 we cannot open a ssh session to our 4510+R Switch. Before the upgrade everything works fine. The error message in the log is:%SSH-3-BAD_PACK_LEN: Bad packet lenghthWe zeroised the rsa key and generate i...
I am sure that I missing something simple in my understanding of how this works. I have connected my virtual CML lab to my network through the external connector. I am able to reach the internet from my edge router. However, for some reason I can not...
Hello,I have subnet like this :My pc under vlan 100 (192.168.100.0/24)My NAS under vlan 150 (192.168.150.0/24)Actually when the nas and pc located under same subnet, I can discovery the nas from my laptop using vendor utility, but can't discover when...
When registering devices on the Smart Account for licencing, how do you license all members in a stackwise-virtual stack? I have two C9500-24Y4C devices currently in my network, they are connected in a stackwise-virtual link. I have registered the ma...
I have an ISR 1K with DUAL ISPs (Dialer0 & Cellular) My intention was to implement something similar to this article: https://learningnetwork.cisco.com/s/question/0D53i00000Kt1XYCAZ/nat-failover-with-dual-isp-on-a-router-configuration-example?t=17103...
Hello, everyone. Our compnay is going to upgrade C9200 software. Can we directly upgrade C9200-48P from 17.03.03 to 17.09.04? 您好,最近相对公司的 C9200 交换机进行软件升级,目前交换机的软件版本是 17.03.03,可以直接升级到最新版本 17.09.04 吗?有没有需要注意的地方?
Dear friends,We are planning to deploy new SD-Access and SD-WAN infrastructure, but I had a few questions:Is it possible to connect remote branch SD-access equipment (DNA access switches) behind SD-WAN router? I mean to see it in Fabric, configure vi...
Hi guys, today I have a little problem with SDA-transit and I am not sure, if I am doing it wrong or DNAC (or CC). I have a customer and we want to migrate to a SDA fabric solution. The customer has different remote locations where we can use higher ...
i try to install it on kali but this error still exist The following packages have unmet dependencies: packettracer: Depends: libgl1-mesa-glx but it is not installable
Hello, since november 2023, when our cisco prime 3.10.4 trying to get the config via ssh from our 4510+R Switch, the privilege level 15 changed to 1 and the ssh connection fails. Bevor the config was archived correctily. This problem only occours wit...
Hello,I have topology like this picture where we have 2 WAN connection to bridge LAN1 and LAN2. We use OSFP for the routing and we have NPM (from solarwinds) to monitor WAN connection from LAN1.In the NPM i create 2 node with ip 10.100.1.2 and 10.101...
Hi,Is it possible to configure an MPLS VRF without the use of RDs? I have tried to get this to work in a lab but have been unsuccessful (I have always had to use RD to get it to work)If I were to set up a MPLS VPN between a Nexus switch which has VR...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: