cisco ip phone 12 sp+

Unanswered Question
Jan 31st, 2007


I have a cisco IP phone 12 sp+. I was trying to configure it with asterisk 1.2 which runs in Fedora Linux.I am able to get dial tone from the cisco phone,registered with asterisk at Line=>3.

Now, when i dial any number it gives the following message,

"Asked to indicate 'stop tone'

condition on channel [email protected]"

It is collecting digit what i type follows this message and repeats this message..... No ringing tone.

Any help would be greatly appreciated.

Thanking you,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
b.speltz Tue, 02/06/2007 - 06:28

Check if asterisk supports SCCP other wise need to load a firmware for h.323 or SIP.


This Discussion