01-31-2007 02:04 AM - edited 03-05-2019 02:04 PM
Hi, I can not see anything on my 3640 router with IOS 12.0 and config register value 0x3922.
Please adivse me console settings for windows-hyper terminal.
01-31-2007 02:31 AM
0x3922
Ignores break
*
Boots into ROM if initial boot fails
115200 console baud rate
01-31-2007 02:35 AM
I did it, still can not see any display..what about flow clontrol,stop bits and flow control?.
01-31-2007 03:50 AM
The console connection usually is set with 8 bits, 1 stop bit (I have also seen it work with 2 stop bits), and no flow control.
HTH
Rick
02-01-2007 05:55 PM
It woring with 115200-8-N-1 Combination. Thanks for tips But problems is unable to reset enable secret becuase my config register is 0x 3922, which ignores the BREAK sequence.
How can I reset my enable secret.Thanks in advance.
01-31-2007 10:00 AM
Fist make sure u r on the correct port COM.
Second, the setup is : 9600, 8, none,1, off.
01-31-2007 09:48 PM
change the baud rates 1 by 1 n check what is showing in screen
if ASCII characters is shown on 9600 baud rate then check on higher your problem will surely solve
One thing more have u put Console connector in AUX interface or Console interface because some time people forget this things
Hope this may help you
B.Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
