DMVPN - Split tunneling

Unanswered Question
Jan 31st, 2007

Hello

I am setting up a DMVPN-solution. 2 Hubs (primary/backup) at the main site, connected to the same mGRE tunnel "cloud".

When setting up the spokes, I first configure basic internet-access, NAT and such. Before doing any DMVPN-config I can from inside reach internet. However, as soon as I configure DMVPN (SDM DMVPN Wizard) I loose internet connectivity from LAN.

I guess that the DMVPN wizard configures the router to tunnel everything. Am I right? I am not interrested in tunneling outgoing internet-traffic, only traffic from my Spoke LAN to a few LAN:s behind my DMVPN-Hub.

Is there any way to specify that only traffic from XXX to YY should enter the GRE tunnel?

The spoke configuration is attached.

Best Regards

Jimmy Larsson

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion