Show running configuration command

Unanswered Question
Jan 31st, 2007

I had configured a 1801 and 1750 series router with a line aux 0 for dial-up backup with a speed of 115200, but every time I type the show running config command these line changes to whatever value.

Could you tell why?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
dmetheny1 Fri, 02/02/2007 - 13:49

This could be an indication that your router and modem aren't talking to one another. I suspect that the dial backup isn't working like you want it to.

Physical connectivity, aux port config, modem dip switch settings, modem cap, etc.

Check here:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a008009428b.shtml

And here:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a0080094bbc.shtml

I hope this helps. Please rate as appropriate.

Actions

This Discussion