How many queues on a serial interface?

Unanswered Question
Jan 31st, 2007

Hi,

is there a command that show me how many queues are active on an interface?

1, 2, 3, etc....

with sh queue serial 0/1/0 I can see the number of conversations but on wich queue are those flows????

thanks a lot

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
mheusinger Wed, 01/31/2007 - 07:40

Hi,

(software) queues you are refering to are only involved, IF there is an overload situation. If the interface is not overloaded, all packets are immediately sent into the hardware queue (tx-ring). Thus packets are bypassing the software queues in this case.

If an overload situation exists, the command "sh queue serial 0/1/0" will give you a momentarily picture of your queues. The queuenumber is denoted as "Conversation ".

Regards, Martin

Actions

This Discussion