change inside interface speed for pix 501

Unanswered Question

Hi,

For some reason I can't change the speed on the inside interface on the pix 501. Whenever I try to use the command (interface ethernet1 10full) it comes back with the message: "ethernet1 can only be set to 100full".

Is there a way to change the speed? I need to do this beause of an mck box for voice over ip, it only works on 10baset network speeds.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Andy Robinson Thu, 02/01/2007 - 08:32

As far as I know you can't do it because it is a four port unmanaged switch, not a single ethernet.

jain.nitin Sun, 02/11/2007 - 04:01

Hi, Try to set 10Half or leave it in auto mode. It will negotiate the Speed & duplex with peering device like phone/PC whatever.

Ninja

Actions

This Discussion