Wrong software for this hardware (3660)

Unanswered Question
Jan 31st, 2007

Hi guys, we are having some troubles with this 3660 router. We just installed 2 internal Flash cards of 8 Mb each. After trying to upload an IOS (an IOS that we are using in another same model router, we keep getting the "Wrong system software for this hardware" message. You can check this:

System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc.

C3660 processor with 65536 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled

rommon 1 > xmodem -c c3660-is-mz.122-6.bin Do not start the sending program yet...

File size Checksum File name

14998716 bytes (0xe4dcbc) 0x2de4 c3660-is-mz.122-8.T5.bin

WARNING: All existing data in flash will be lost!

Invoke this application only for disaster recovery.

Do you wish to continue? y/n [n]: y

Ready to receive file c3660-is-mz.122-6.bin ...

Erasing flash at 0x30fc0000

program flash location 0x30aa0000

Download Complete!

program load complete, entry point: 0x80008000, size: 0xaa50d4 Self decompressing the image : #################################################

################################################################################

################################################################################

############################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################## [OK]

Smart Init is enabled

smart init is sizing iomem

ID MEMORY_REQ TYPE

0000B3 0X0009FC00 Dual Port Fast Ethernet

0000CC 0X00164794 High Density Voice Port Module

00003B 0X001AA000 Two CE1 - Unbalanced (75 Ohm - Coax)

0X00280000 OIR memory

0X000F3BB0 public buffer pools

0X00211000 public particle pools

TOTAL: 0X00932F44

If any of the above Memory Requirements are "UNKNOWN", you may be using an unsupported configuration or there is a software problem and system operation may be compromised.

Rounded IOMEM up to: 10Mb.

Using 15 percent iomem. [10Mb/64Mb]

Wrong system software for this hardware

System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc.

C3660 processor with 65536 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled

rommon 1 >

Can you guys help? Thanks in advance!!

Omar Montes

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ankurjain05 Wed, 01/31/2007 - 22:08

Try using different IOS of different feature set and version.

and try to resit the flash and ram again on the motherboard of the router.

That might help

s.conway Wed, 01/31/2007 - 22:26

What is the bootstrap version on the router that you're already running this code level 12.2?

This router is running System Bootstrap, Version 12.0(6r)T,

Maybe you need to upgrade the bootstrap code first.

Actions

This Discussion