02-01-2007 02:16 PM - edited 03-11-2019 02:27 AM
Whcih command is used to enable intervlan comm. in FWSM?
02-01-2007 03:38 PM
Hi,
I don't think this is possible with FWSM. you might want to have two interfces with same seurity level talking to each other. though intervlan routing may not be an option with firewall else the firewall functionality might not be used.
you can enable interfaces on the same security level to communicate with each other using "FWSM(config)# same-security-traffic permit inter-interface"
Thanks
gagan
02-01-2007 03:44 PM
hi aksher,
try this...
static (HSV,LSV)LSV IP HSV IP nemask X.X.X.X.
u might be knowing this
HSV - high secure vlan
LSV - low secure vlan
all the best.it should work
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: