PIX to Windows Server Tunnel

Unanswered Question

Hi, looking here http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800b12b5.shtml it seems i can configure a tunnel vpn between my pix and a remote site server running windows server.

My question is, how would i get the pix to route traffic (in the example link above) over the tunnel, to be routed on by the windows server? Would the pix have an additional virtual tunnel interface for use once the tunnel is specified?

Also, it seems to read both ends of the link require a static address? Is there any possibility of using a dynamic address one side and static the other?

Many thanks,

Chris

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion