PIX interfaces ????

Unanswered Question
Feb 2nd, 2007

hi

we are configuring a PIX 525 and facing a prob that after assing the Ip add to an interface we have observed that interfce is administravitivly Down what can i do,,

I have read on cisco site intsert new card in it and than use write mem for it i could nt unserstand it .. can you tell us abuot it..

which new card ????

Thanks and regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
vijayasankar Fri, 02/02/2007 - 03:23

Hi,

By default all the interfaces will be in shut state in the configuration.

Try issuing "no shut" on the interface configuration mode and saving the configuration.

-VJ

talisman1310 Fri, 02/02/2007 - 04:02

doind a no shut in the particular interface will not work for a firewall.

Try the following syntax....

interface < hardware_id>

eg:

interface ethernet0 100full

interface ethernet1 100full

Actions

This Discussion