MSFC card not loading on SUP2 Module (6509)

Unanswered Question
Feb 2nd, 2007

I have a load issue I cannot seem to rectify.

When the SUP2 module loaded the CatOS 6.3.3 I went into session 15 to access the MSFC card I found the prompt was router(boot)

I guess this mean that no valid IOS was found on the bootflash:

I did a dir bootflash: and found 2 versions of IOS to load.

I went into "conf t" and did a boot system bootflash:<IOS filename> and reloaded the 6500.

Session 15 no longer comes online. I guess the IOS was corrupt or invalid.

I cannot seem to get into session 15 anymore.

I do a show module 15 and it tells me the module is offline

Any ideas.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pciaccio Fri, 02/02/2007 - 04:07

Try using the SWITCH CONSOLE 15 command to get into the MSFC. From their you can set up the correct IOS to boot off of..Good Luck....

glen.grant Fri, 02/02/2007 - 04:47

Check the config register on the msfc and make sure it is 0x2102 and the image you are trying to load is a valid Sup2 MSFC image.

Actions

This Discussion