cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
332
Views
0
Helpful
3
Replies

DEAD 2940?

edemusmaximus
Level 1
Level 1

Not really dead, but just made the mistake of erasing the flash and NVRAM. Anyways, I am fairly new to networking, and I am trying to load the IOS to the flash. How do I do that? TFTP server? What is the actual, step by step command?

3 Replies 3

sachinraja
Level 9
Level 9

Hello,

Is the switch on rommmon mode now? If so, you can use the xmodem commandsets to upload the IOS through the hyperterminal. You have to be on the console of the switch for this. you can then use the command :

xmodem -c imagename 115200

where 115200 is the speed at which the upload will happen..

Refer to this link for more info:

http://cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml

Hope this helps.. all the best... rate replies if found useful..

Raj

Thanks Raj, I think that will work.

Test it and let us know in case of any issues.. if it works, mark the case as solved, which can help others.. rate replies if useful.

Raj

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco