I am using a Cisco AP
Product/Model Number: AIR-AP1231G-A-K9
Top Assembly Serial Number: FHK1015J0NA
System Software Filename: c1200-k9w7-tar.123-4.JA2
System Software Version: 12.3(4)JA2
Bootloader Version: 12.3(2)JA4
I am using WEP 40-bit authentication
I am able to get the IP address and also able to go online
As and when I try to use MAC-Authentication and configure filters and apply them on 802.11g, the clients are not able to pull up IP addresses,
Instead I am getting apipa address on the clients.
The same model accesspoint with the same software and model in another location i am able to use it fine.
I am not able to understand what might have happened??
I had done a lot of R&D on this, tried reconfiguring, tried re-connecting etc
Please suggest me a solution for this
Thanks in advance