02-05-2007 01:10 AM - edited 03-11-2019 02:29 AM
Hi
I have a pair of asa5520 configured as active/standby failover pair.
I have a requirement to carry UDP video conferencing sessions through my firewall.
During testing I made a video call from a unit on the inside to the outside. The call establishes fine.
I then Fail and interface on the active/Primary unit, the standby becomes active and the remains up (image freezes for 5 secs, which is fine).
If I reconnect the interface on the primary, wait a minute or two and fail an interface on the active/Secondary unit, the call freezes for 5 secs and then resumes.
After approx 60 secs running on the active/Primary the call drops?
I this right?
The video call is a standard H323 call using Tanberg units.
02-05-2007 10:56 AM
Can you post your failover config ? Failover should be stateful for H323.
02-06-2007 12:43 AM
It works fine when I turn off the h323 inspection rule
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: