X25 call

olivierchambon · ‎02-05-2007

I have a serial interface on a router with X25 configured. this serial interface is attached to a device which is making x25 calls. This device is supposed to pick the X25 address from our interface. but I can't get any x25 call. Show x25 vc doesn't display anything

The interface configuration is :

interface Serial1/7

description Alarm **** device

no ip address

encapsulation x25 dce

no ip mroute-cache

x25 htc 16

x25 win 4

x25 wout 4

x25 ips 256

x25 ops 256

x25 use-source-address

no ignore-hw local-loopback

clock rate 9600

no cdp enable

end.

and the debug is attached.

From the debug what would be the cause of this?

thomas.chen · ‎02-09-2007

May be this is an address translation issue by the switch.To omit the source address in outgoing calls, use the x25 suppress-calling-address interface configuration command. Refer URL

http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/wan_r/wrx25.htm#10324

smothuku · ‎02-10-2007

Hi,

The following link may help you

By seeing the cause code and diag code it is understood that there is a """Invalid calling address"""".First check the calling address

http://www.cisco.com/en/US/partner/products/ps6441/products_command_reference_chapter09186a00804ab4b8.html#wp1003513

http://www.cisco.com/en/US/partner/tech/tk713/tk730/technologies_configuration_example09186a0080094370.shtml

Thanks,

satish