I am trying to configure my CME for site to site outbound calls...

Unanswered Question
Feb 5th, 2007

I keep getting error msg "sorry you call didn't go through" when trying to make outbound calls from site to site with 10 digit dialing throught the PSTN....PRI connected..Controllers up....I can make extension to extension calls

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Brandon Buffin Mon, 02/05/2007 - 13:49

Can you make other inbound/outbound calls at these sites, just not between the sites? Can you post your configs?

Brandon

dgahm Mon, 02/05/2007 - 17:13

Here is a problem with the Newport config. The forward digits 0 says send out no digits. If you remove that everything after the 8 will be sent, which is probably what you want.

dial-peer voice 3 pots

destination-pattern 8T

incoming called-number .

port 0/2/0:0

forward-digits 0

To see what is actually being sent use debug vpm signal and place a call.

Please rate helpful posts.

gracianogardunojr Wed, 02/07/2007 - 14:24

Try this dial-peer.

dial-peer voice 42 pots

description National calls

destination-pattern 81[2-9]..[2-9]......

port 0/2/0:0

forward-digits 11

Actions

This Discussion