conf ISDN PRI OK with 2621 but don't work on 28XX

Unanswered Question
Feb 6th, 2007

HI,

I have read previous mesage and haven't found a answer of my problem.

I have a problem of connexion on PRI.

When I use a 2621 with this conf, it work fine:

controller E1 0/0/0

framing NO-CRC4

pri-group timeslots 1-16

!

!

interface Serial0/0/0:15

no ip address

encapsulation ppp

dialer pool-member 23

isdn switch-type primary-net5

ppp authentication chap

ppp multilink

!

interface Dialer23

ip address X.X.X.2 255.255.255.0

encapsulation ppp

dialer pool 23

dialer remote-name REMOTE_SITE

dialer fast-idle 240

dialer string XXXXXXXXX

dialer-group 1

no cdp enable

ppp multilink

!

dialer-list 1 protocol ip permit

when I use the same on 28XX, there is no communication

boot system flash c2800nm-ipbase-mz.123-11.T7.bin

network-clock-participate wic 0

network-clock-select 1 E1 0/0/0

<removed>

!

!

controller E1 0/0/0

framing NO-CRC4

pri-group timeslots 1-16

!

interface Serial0/0/0:15

no ip address

encapsulation ppp

dialer pool-member 23

isdn switch-type primary-net5

isdn incoming-voice data

ppp authentication chap

ppp multilink

!

interface Dialer23

ip address 10.101.123.2 255.255.255.0

encapsulation ppp

dialer pool 23

dialer remote-name REMOTE_SITE

dialer fast-idle 240

dialer string XXXXXXXX

dialer-group 1

no cdp enable

ppp multilink

....

dialer-list 1 protocol ip permit

_______________

I have the following output

%CONTROLLER-5-UPDOWN: Controller E1 0/0/0, changed state to up

Feb 6 09:58:49.477: ISDN Se0/0/0:15 SERROR: service_queue_from_physical_layer: got ISDN_PH_ACT_IND on an active interface?

Feb 6 09:58:51.477: %LINK-3-UPDOWN: Interface Serial0/0/0:15, changed state to up

Feb 6 10:01:54.695: ISDN Se0/0/0:15 SERROR: isdn_get_guid: Cannot allocate a GUID (5).....

Is there anybody has a idea of the cause of this problem.

What mean "Cannot allocate a GUID" and "ISDN_PH_ACT_IND"?

thank you for your help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion