And the question is ?
Using CallManager, the clir is restricted by a checkbox somewhere is the configuration.
In all the other cases, if you want CLIR (calling number information restricted), configure "clid restrict" in the outbound dial-peer. The outgoing setup message will be then like:
ISDN BR0/0/0 Q931: TX -> SETUP pd = 8 callref = 0x40
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0x89
Exclusive, B1
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x00A0, '28293031' <-- NOTE i is set to 0xA0 to mean CLIR
Plan:Unknown, Type:Unknown
Called Party Number i = 0x80, '68783347'
Plan:Unknown, Type:Unknown
Sending Complete