continual coverage threshold violation

Unanswered Question
Feb 6th, 2007

Hi,

I seem to get these messages from an 1130 LW, using a 4400 as the controller. Exactly every 20 minutes for the wholes days. Im around 10 meters away from the AP, and every now and then I get a low signal, then the wireless disconnects and reconnects.

AP 'comp-1130', interface '802.11b/g' on Controller '10.*.*.*'. Coverage threshold of 'unknown' violated. Total no of clients is 'unknown' and no of failed clients is 'unknown'.

The AP is between two other AP's. The other two have no problems. In the area, there are several 7920's and a couple other laptops that use the AP's continually.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode