SOL !!! plz chk the configuration ?????

Unanswered Question
Feb 7th, 2007

Hi

plz cck also the attached network PIc,

I have to provide bandwidth to the Customer router of 2 MB.

Router-A is our core router(BGP running).

Router-B is edge router("static routing" we are using it for our provate network).

Customer router need 2MB

Plz chk the E1 config and suggest!!!!

Router A

ccontroller E1 0/1

clock source internal

channel-group 1 timeslots 1-31

nterface Serial0/1:1

bandwidth 2048

ip address 192.168.15.1 255.255.255.252

-----------------------------------------------------

Router B

(For A router)

controller E1 0/1

clock source line primary

channel-group 1 timeslots 1-31

nterface Serial0/1:1

ip address 192.168.15.2 255.255.255.252

(For Customer router)

controller E1 0/0

clock source internal

channel-group 0 timeslots 1-31

interface Serial0/0:0

ip address 192.168.14.1 255.255.255.252

ip route x.x.x.x .x.x.x.x s0/1:1

-------------------------------------------------

Coustomer Router

controller E1 0/0

clock source internal

channel-group 0 timeslots 1-31

description LHR-ISB

interface Serial0/0:0

description LHR-ISB

ip address 192.168.14.2 255.255.255.252

Routing

ip route x.x.x.x .x.x.x.x s0/0:0

-----------------------------------------

plz sugget if there is any problem is the above config..

Best regards

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Wed, 02/07/2007 - 02:58

Hi Afzaal

If you are providing public ip space to the customer Local area network then you need to route the traffic pointing towards the serial which is connecting towards the customer end.

Also make sure you have the reachability to the customer local area network from your core router.

Once the same is done you can verify the same by checking reverese trace from any of the route servers..

regds

Actions

This Discussion