NM-HDV2-2T1/E1 connected to Lucent Definity

Unanswered Question
Feb 8th, 2007

I'm trying to setup a E1 connection between a 3825 with a NM-HDV2-2T1/E1 connected to Lucent Definity. I?m having problems because on the side of the router the E1 controller is UP and error counters aren't increasing, but I cannot receive or make calls through that E1. Also while monitoring the status of E1 channels on the Lucent sometimes they appear as "out-of-service".

This link was initially working between the same Lucent Definity and a 3660 with a NM-HDV-1E1-30.

I inserted this same NM-HDV-1E1-30 on the new 3825 and using the exact same configuration it worked for this connection.

Is there anything special I should know about the NM-HDV2-2T1/E1? (configuration, hardware, etc)

Here is the configuration:

controller E1 1/1

framing NO-CRC4

ds0-group 1 timeslots 1-15,17-31 type e&m-wink-start

cas-custom 1

!

voice-port 1/1:1

input gain 2

output attenuation 2

echo-cancel coverage 24

cptone MX

bearer-cap Speech

!

Thanks,

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion