02-09-2007 12:16 PM - edited 03-05-2019 02:16 PM
hello all,
I have a 6509 switch running Software 8.2(2) with 2 sup modules.
i am looking for a command that will show all the ip addresses that are mapped to all the ports on the switch.
Does such a command exist at all?
Thanks in advance.
02-09-2007 12:38 PM
You can only check the MAC address --> port mapping on a layer 2 switch. 'show cam dynamic' will display all the MAC to port mapping. It's a two step process to find out which port on the switch a host is connected to. To find out which port a host is connected you need to get the MAC address of the device from the ARP table on the layer 3 gateway (Router/layer 3 switch like MSFC) by doing 'show ip arp' and then do a 'show cam (mac_address) vlan (id)'. If you know the MAC of the host you want to lookup the port then you can skip the first step.
HTH
Sundar
02-09-2007 03:49 PM
I thought so.
Thanks a bunch....i wish cisco would come up with a command that would show all ip address that are specifically mapped to the ports.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: