MPLS on Port-Channel

Unanswered Question
Feb 12th, 2007

Is it possible to configure TE on a Port-Channel ?

I don't see the command mpls traffic-eng tunnels

CSCO-CORE-SPO(config-subif)#mpls ?

accounting Enable MPLS accounting on this interface

bgp MPLS BGP

ip Configure dynamic MPLS forwarding for IP

l2transport Layer 2 packet over MPLS config commands

label Label properties

ldp Configure Label Distribution Protocol (LDP) parameters

mtu Set MPLS Maximum Transmission Unit

netflow Configure Egress Netflow Accounting

CSCO-CORE-SPO(config-subif)#mpls tr

CSCO-CORE-SPO(config-subif)#mpls

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
azago Thu, 02/15/2007 - 03:37

s72033-advipservicesk9_wan-mz.122-33.SRA2.bin

aheinz Thu, 02/15/2007 - 06:14

Try:

interface GigabitEthernet1/2

channel-group 1 mode active

!

interface GigabitEthernet1/3

channel-group 1 mode active

!

interface Port-channel 1

switch-port

switch-port access vlan 1507

switch-port mode access

!

interface vlan 1507

mpls traffic-eng tunnels

mpls traffic-eng backup-path Tunnel1

mpls ip

Rgds

Andreas

aheinz Thu, 02/15/2007 - 08:09

if you can't change to that config, use 12.2.18.sxf 5 or wait until it is supported in SR.

Rgds

Andreas

Actions

This Discussion