Eth and Serial port with RIP

Unanswered Question
Feb 12th, 2007

In a situation of two router linked by the serial ports and the fastethernet

port of each router to each of their segment...

Router A Router B

A Segment <------> FastEth FastEth <------> B Segment

Serial <-------> Serial

To be able to send from A to B or vice versa

For Router A

#router rip

#network <IP>

!!!!!Here the <IP> is of which port....

For Router B

#router rip

#network <IP>

!!!!!Here the <IP> is of which port....

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Mon, 02/12/2007 - 10:59

Prakash

I do not fully understand your explanation of the topology and perhaps do not fully understand your question. But I believe that the answer you are looking for is that unless you are going to do something in RIP like redistribute connected, then there must be network statements under router rip that include both the interface(s) that rip will advertise over and also network statements that include the segments where end user stations are located that you want to advertise. So in your case it is the IP of both the serial and the etheret ports.

HTH

Rick

Desiles1011 Mon, 02/12/2007 - 12:01

Router A Router B

A Segment <------> FastEth FastEth <------> B Segment

Serial <-------> Serial

Desiles1011 Mon, 02/12/2007 - 12:03

Router A Router B

A Segment <--> FastEth ----- FastEth <-> B Segment

Serial <---- Serial

Actions

This Discussion