Internet VPN with 1Mbps rate limit

fmatrine · ‎02-12-2007

Hi All,

We are looking for Internet Leased Line of bandwidth 4Mbps, IP details are /27 IP Public pool for Lan segment.Interface on the lan and wan side will be ethernet.

/29 Wan IP address is proposed for building four site to site VPN with other locations.

Different Source IP to be used for forming individual Site-to-Site VPN session.

Each site-to-site vpn session should be rate limited to 1Mbps based on the WAN IP.

Pls advice with sample config on how can we acheive this.

Also refer the attached schematic for details.

wdrootz · ‎02-16-2007

In a hub-and-spoke VPN topology, multiple remote devices (spokes) communicate securely with a central device (hub). A separate, secured . Take a look a the following.

http://cisco.com/en/US/products/ps6498/products_user_guide_chapter09186a00806c27a7.html#wp1371212

hoogen_82 · ‎02-17-2007

Hi,

This link should help you out with your VPN configurations

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009463b.shtml

Regarding rate limiting you could do this by enabling the rate-limit command int the output direction but ensuring that you match the intresting traffic with the same acls you define intresting traffic for the VPN tunnel.

Cheers

Hoogen

shantharam.suryanarayana · ‎02-19-2007

Hi,

As I have understood, you have taken 4Mbps internet bandwidth at your central location and 1Mbps at each remote location from the same ISP.

In this case you need not worry about limiting bandwidth, your ISP will take care of it. Your only concern will be on data security.

Regards

S. Shantharam