E1 enable

Unanswered Question
Feb 13th, 2007

I installed 1 2MFT VWIC card in 2821 router if I command sh ver I see this card detect but sh run command I can?t see it any controller how can I enable it for E1 configuration

Thanks

robin

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Tue, 02/13/2007 - 21:18

Hi Robin

Can you post the output of show version here ?

Also have you tried configuring card type e1 ?

regds

royalblues Wed, 02/14/2007 - 05:05

Hi friend,

I think you are using a version 2 card.

In this case you require the following command

(config)#card type e1/t1

eg. card type e1 0 1

HTH, rate if it does

Narayan

Actions

This Discussion