Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
255
Views
0
Helpful
2
Replies

E1 enable

robinsiddiquey
Level 1
Level 1

‎02-13-2007 09:04 PM - edited ‎03-03-2019 03:44 PM

I installed 1 2MFT VWIC card in 2821 router if I command sh ver I see this card detect but sh run command I can?t see it any controller how can I enable it for E1 configuration

Thanks

robin

Labels:
0 Helpful
2 Replies 2

spremkumar
Level 9
Level 9

‎02-13-2007 09:18 PM

Hi Robin

Can you post the output of show version here ?

Also have you tried configuring card type e1 ?

regds

0 Helpful

royalblues
Level 10
Level 10
In response to spremkumar

‎02-14-2007 05:05 AM

Hi friend,

I think you are using a version 2 card.

In this case you require the following command

(config)#card type e1/t1

eg. card type e1 0 1

HTH, rate if it does

Narayan

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card