Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
242
Views
0
Helpful
1
Replies

Data T1 configuration with controller command

ciscoforum
Level 1
Level 1

‎02-14-2007 07:51 AM - edited ‎03-14-2019 08:01 PM

Has anybody configured a data T1 by using controller t1 command? What I have seen is T1 Dsu kind of wic which doesn't use controller command, instead using service-module command, which there is no show controller for that. The reason I am asking this is that one of our customer said that they have slip on data T1. Before I asked them which t1 module they use I would like to know from you guys. Thanks

Labels:
0 Helpful
1 Reply 1

timmektrakarn
Level 1
Level 1

‎02-14-2007 11:54 AM

You use the channel-group sub command on the controller t1 for that kind of T1 module. If you're experiencing slips you should check the clocking. Most of the time it should be set to line.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents